Chlorifix® | Bayrol
You are looking for
A product, pool maintenance tips, solutions to the most common water problems?
Chlorifix®
Private pool Commercial pool 2) Permanent disinfection

High-quality chlorine granules for shock treatment in case of water problems. Quickly and effectively increases the active chlorine content. Less dust due to the special granular form.

  • For all filter types
  • For all pool sizes
  • Where: directly into the water
  • When: in case of water problems
  • Dosage: 200g per 10m³
  • Homme_piscine
    Stabichloran_BAYROL_granules.jpg
    5533111-Chlorifix_1kg

    Chlorifix® are fast-dissolving organic chlorine granules for shock treatment that work immediately against bacteria, fungi and viruses and break down organic turbidity and impurities in swimming pool water. They dissolve without leaving residue and don't cause deposits or clogged filters.

    Chlorifix® is particularly suitable for shock treatment in case of water problems. The fast-dissolving granules release a large amount of active chlorine immediately after being added to the pool water. Microorganisms, responsible for cloudy water and algae that turn the water green, are oxidized. Within a few hours, the pool water becomes clear and pure again.  

    Chlorifix® contains isocyanuric acid and thus protects the chlorine from UV. Ideal for outdoor pools, especially salt water pools. Thanks to the use of a high-quality raw material with a high chlorine content and the special granular form, less dust is released compared to standards chlorine granules. This provides more safety in handling.

    • Benefits
      Antiscale, pH-neutral
      Fast dissolving and no residue

      do not clog filters and automatic dosing systems

      Can be used for any water hardness

      does not influence the pH of the pool water

      Stabilizing effect

      limits the degradation of active chlorine by UV at high water temperatures

      Granules to prevent dust
    • Use

      Use biocidal products with care. Always read label and product information before use.

      This product is to be used exclusively for the specified purpose in accordance with this description.

      • Before adding, check the pH with BAYROL test strips and, if necessary, adjust it to the ideal range of 7.0 to 7.4.
      • In case of water problems, add 200g of Chlorifix® per 10m³ directly to the water with the circulation pump running.
      • The addition should preferably be done in the evening after bathing. Let the circulation pump run for 12 hours.
      • Do not bathe again until the chlorine level has dropped below 3mg/L.
      • For a basic chlorination, dose 50g per 10m³.

      Tip: To prevent algae growth, we recommend the regular addition of Desalgine® Jet. In the event of lots of bathers, storms and high temperatures, it is required to increase or double the amount of tablets.

      Important Notes: Be sure to avoid direct contact with materials that are not resistant to chlorine. To reliably avoid bleach spots in foil or painted pools, add Chlorifix® via the skimmer or dissolve it with water in plastic buckets beforehand. First add water, then Chlorifix®.

    • Resources