Calcinex®
Find a retailer-
For all filter types
-
For all pool sizes
-
Where: directly into the pool water
-
When: as needed, immediately after filling the pool
-
Dosage: 300ml per 10m³
Always read label and product information before use.
This product is to be used exclusively for the specified purpose in accordance with this description.
- Add 300ml of Calcinex® per 10m³ immediately after filling the pool with the circulating pump running.
- After dosing, let the circulation pump run for at least two hours to allow the product to spread out well in the pool.
- For water temperatures above 28°C, it is recommended to increase the dosage by 50%.
- If fresh water is added after backwashing, re-dosing is required.
Tip: The pool water must be circulated continuously. To calculate the circulation time, the following rule of thumb applies: water temperature: 2 = circulation time per day.
Important notes: Calcinex® acts preventively against water discolouration by metals. Metals or discolouration that has already precipitated cannot be removed. Never mix chemicals with other chemicals, neither in solid form nor in concentrated solution! When preparing solutions, always dose product into water, not vice versa.
Product benefits
-
Prevents water turbidity and calcium deposits
on pool surfaces and built-in parts
-
and thus prevents water discolouration caused by metal ions
pH-neutral
-
does not add additional algae food to the water
Calcinex® is a concentrated liquid preventing calcium and metal deposits on pool walls and bottom (especially in very hard water). Due to the special formula, Calcinex® is also stable in chlorine-, bromine- or oxygen-maintained pools and maintains its full effectiveness.
The active ingredient contained in Calcinex® ensures (especially in hard water), that calcium and metal deposits remains in suspension and therefore cannot settle on the walls and floor. This prevents the formation of rough surfaces and can cause damage on pool surfaces.
Important notes: Calcinex® acts preventively against water discolourations caused by metals (already precipitated metals or discolourations can not be removed again).
Pool limescale remover – Frequently asked questions (FAQ)
-
Limescale will quickly damage your pool equipment (pump, filter, lining), shortening its lifespan or requiring thorough cleaning to remove deposits.
As Calcinex is a 2-in-1 product, it will also sequester the metals present in the water, thereby preventing them from precipitating (stains on your pool lining).
-
If your water is hard (high total hardness), limescale can build up quickly. Deposits, stains, limescale on the walls, cloudy water… Clear water starts with effective prevention. The best solution for limescale in hard water is Calcinex®, to be used:
- as soon as you start up your pool at the beginning of the season
- and every time you add fresh water.
-
If the water is hard, the Calcinex limescale and metal complex prevents limescale deposits and metal stains in the pool. Calcinex does not affect the water’s pH. Its neutral formula preserves the water’s balance.
-
Adding Calcinex® at the start of the season and maintaining the pH between 7.0 and 7.4 will prevent limescale deposits.
-
Swimming is possible a few minutes after adding Calcinex®.
Related products
Highly effective pool cleaner that removes persistent limescale, metal and dirt deposits from pool walls and floors.
Ready-to-use liquid spray for cleaning the waterline and inside the pool skimmer.
Ready-to-use liquid with 2-in-1 formula. Protects the waterline from dirt deposits and ensures crystal clear and sparkling pool water.
Chlorine tablet 200g for the dual disinfection of sand filters.
